Skip to main content

Development and research of formation technologies on specialized presses with subsequent sintering of high-density details from iron-based powders

Записки Горного института
© Форпост Северо-Запад / Андрей Кучеренко

ELECTROMECHANICS AND MECHANICAL ENGINEERING

Aleksandr M. Dmitriev, Doctor of Engineering Sciences, Professor, Corresponding Member RAS, Moscow State Technological University «STANKIN», Moscow, Russia;

Nataliya V. Korobova, Doctor of Engineering Sciences, Head of Department, Expert of RAS, Moscow State Technological University «STANKIN», Moscow, Russia;

Ashot Zh. Badalyan, Candidate of Engineering Sciences, Lecturer, Moscow State Technological University «STANKIN», Moscow, Russia.

Abstract

Creating shifts of the lyaers in a deforming workpieces improves the quality of the product produced by pressure treatment. qual-channel angular pressing and precipitations of a cylindrical billet with a rotating turnaround were developed by specialists earlier and became basic for scientists engaged in nanotechnology. One of the most modern schemes for creating nanostructures by processing on presses is the «Cyclic Extrusion Compression» scheme (in Russia – «Hourglass»), which has significant drawbacks.

To date, research on the creation of layer shifts in compacted metal powders is substantially less than in compaction of compact blanks. The article developed compaction schemes for presses of blanks from iron-based powders that have a certain analogy with the «Hourglass», while lacking the disadvantages inherent in the named scheme and implemented on the created samples of specialized hydraulic presses. The results of the studies of density, strength and microhardness before sintering the samples molded from a number of domestic and imported powders on iron base, including those doped with carbon and other alloying components, are described.

It has been established that with the use of the formation schemes for powders providing large shifts between particles, the density of the preforms increases on average by 10-12 %. With an average stress (16.32 MPa) of the transverse section of the molded specimen prior to its sintering, molding with shifts between particles increases this stress by 78 %. The strength after sintering of samples made using the compaction schemes developed by the authors of the article increases approximately by 2 times. Magnetic pulse treatment (MPT) of a molded sample prior to its sintering increases its resistance to shearing before sintering, regardless of the molding pattern. When MPT of both the powder and the molded sample is executed, the most uniform distribution of microhardness in the sample is achieved, and after subsequent sintering, the most uniform distribution of the mechanical characteristics of the product. The results of all studies are described by regression equations.

Keywords: powder materials; iron base; cold molding on presses; shifts shaping; high-density samples; mechanical characteristics of the samples before sintering; Influencing magnetic pulse processing during molding; study.

Full text PDF.

Scientifiс periodical «Zapiski Gornogo Instituta / Journal of Mining Institute» has been published since 1907 as a periodical scientific and scientific-educational edition in Saint-Petersburg Mining University. The periodicity of publishing is 6 volumes per year.